From: Owen Wells Date: Wed, 2 Dec 2015 09:57:59 -0500 Subject: [Intel-wired-lan] IGB driver load resets NC-SI interface on Rangeley C2000 Message-ID: <002501d12d11$d5c1b1f0$814515d0$@adiengineering.com> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: intel-wired-lan@osuosl.org List-ID: Hi, I was referred to this email address by Juan Nu?ez Quesada, the application support engineer assigned to our IPS case. We have a BMC connected to Rangeley (Atom C2000) via the NC-SI interface. We are able to get to the LAN to/from the BMC, so that works. The issue is that while Linux is booting, the IGB driver loads and resets the NC-SI interface, causing us to lose connection with the BMC. We can reconnect after the reset, but that is not acceptable to the customer . They need a solid connection. We would like to understand how and why the IGB driver is resetting the NC-SI interface. That technically should not happen the NC-SI interface should be up at all times so that the BMC can stay on the network even when Rangeley is shut down. As an experiment, I did try modifying some EEPROM settings to prevent the IGB driver from resetting the interface. Specifically, I cleared bit 0 of the Initialization Control 4 word in the EEPROM (LAN base address + Offset 0x13) to disable software reset. This does not appear to have an effect. Please assist. Thanks! Owen Wells Senior Staff Hardware Engineer ADI Engineering, A Division of Silicom Cell +1-434-760-0289 Skype owen.wells owen.wells at adiengineering.com www.adiengineering.com -------------- next part -------------- An HTML attachment was scrubbed... URL: