From: "Marius Mertens" Subject: Re: "No chain/target/match by that name" when using -m state Date: Wed, 22 Jun 2005 17:21:08 +0200 Message-ID: <007401c5773e$0c6e2570$4206a8c0@loki> References: <87eeecff050622080541743401@mail.gmail.com> Mime-Version: 1.0 Content-Transfer-Encoding: 7bit Return-path: List-Id: List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Sender: netfilter-bounces@lists.netfilter.org Errors-To: netfilter-bounces@lists.netfilter.org Content-Type: text/plain; format="flowed"; charset="us-ascii"; reply-type="original" To: netfilter@lists.netfilter.org Hi everybody, On Wednesday, June 22, 2005 5:05 PM, Ami Ganguli wrote: > [...] > so I figure I must have the necessary bits installed. > > Any ideas or hints on what I should do next to debug this? It's possible that just the ipt_state module is missing. You can try modprobe ipt_state If it works after that, everything is fine, but if it complains that the module cannot be found, you might have to reconfigure, recompile your kernel (modules) or get another kernel image from your distribution so you have the code either built into the kernel, or as module, where module should be the better choice under normal conditions. Good luck, Marius