From: Craig Robinson Date: Wed, 12 Sep 2007 10:20:04 +0100 Subject: [U-Boot-Users] at91rm9200 - silent console In-Reply-To: <406A31B117F2734987636D6CCC93EE3C02241F6A@ehost011-3.exch011.intermedia.net> Message-ID: <00cd01c7f51e$3f1e68d0$7701a8c0@Circuitree.ltd> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hi Leonid & Ulf Thank-you for the pointers to the atmel patched code and buildroot scripts. Can I confirm with you that the correct way to set up u-boot for an at91rm9200 is to use two boot loaders. Can I also confirm that, to boot from parallel flash, the first stage boot loader is boot.bin and that this will load a gzipped version of u-boot. The fact that the atmel source from Ulf's ftp generates a gzipped binary when built suggests to me that this is so. I've seen different opinions on the newsgroup, including some pretty emphatic ones from Wolfgang that u-boot will just work on its own, and frankly am a bit confused! If u-boot should be started by boot.bin are there any specific CONFIG settings to go along with this? Eg. do we need LOWLEVEL_INIT or not? Also I'd be grateful if you could point me at the CONFIG (if any) needed to boot from parallel flash and not dataflash. I think this used to have something to do with CONFIG_BOOTBINFUNC but now that's been replaced...? Many thanks Craig -----Original Message----- From: Leonid [mailto:Leonid at a-k-a.net] Sent: 10 September 2007 23:20 To: Craig Robinson; u-boot-users at lists.sourceforge.net Subject: RE: [U-Boot-Users] at91rm9200 - silent console Unlike more "traditional" PPC versions of u-boot, at91... U-boot is not the first code running on the board. The first one is normally some small bootstrap, running from dataflash or flash itself - it depends on jumper settings and also u-bbot configuration must be right. Search this list's archives - this question has been discussed many times in different forms. Leonid. -----Original Message----- From: u-boot-users-bounces@lists.sourceforge.net [mailto:u-boot-users-bounces at lists.sourceforge.net] On Behalf Of Craig Robinson Sent: Monday, September 10, 2007 8:46 AM To: u-boot-users at lists.sourceforge.net Subject: [U-Boot-Users] at91rm9200 - silent console Dear List I have a at91rm9200ek based board on which I am trying to get u boot 1.2.0 running, without success. I have also tried to compile and run u-boot for the ek directly from the source, all be it with unmodified at91rm9200dk_config. This does not work either. When I load the uboot.bin into flash (with a J-Link ICE) at 0x10000000 and reboot I get nothing on the DBGU console. Is this what you would expect for an ek board with un-patched 1.2.0 source? No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.5.485 / Virus Database: 269.13.14/999 - Release Date: 10/09/2007 17:43