From: grave Date: Mon, 21 Mar 2005 09:37:35 +0000 Subject: =?iso-8859-1?b?UmWgOiBSZaA6?= [U-Boot-Users] booting uboot from flash on a memec evaluation board In-Reply-To: <20050318173251.1EBFAC1510@atlas.denx.de> (from wd@denx.de on Fri Mar 18 18:32:46 2005) References: <20050318173251.1EBFAC1510@atlas.denx.de> Message-ID: <1111397855l.19618l.0l@ipnnarval> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Le 18.03.2005 18:32:46, Wolfgang Denk a ?crit?: > In message <1111164669l.12024l.4l@ipnnarval> you wrote: > > > > Thanks, but the branch instruction only (as far as I understand) > > support 24 bits address jump and there is only room for one > instruction > > in 0xfffffffc. So I tryed to set a jump to 0xffff8000 where there is > > > What is your problem? To find the address where to boot perhaps ? I compile u-boot with the same monitor address as in the ml300 disign, I put the uboot.srec file in flash, do I need to boot at flash address + 100 ? Thanks in advance, xavier