From: Peter Tyser Date: Tue, 24 Feb 2009 10:10:46 -0600 Subject: [U-Boot] [PATCH 1/7 v4] i2c, dtt: move dtt_init () to board_init_r () In-Reply-To: <49A3CC46.3000602@denx.de> References: <49A3CC46.3000602@denx.de> Message-ID: <1235491846.19570.71.camel@localhost.localdomain> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hi Heiko, On Tue, 2009-02-24 at 11:30 +0100, Heiko Schocher wrote: > In case where a board not uses CONFIG_POST, it is not > necessary to init the DTTs when running from flash. > > Signed-off-by: Heiko Schocher > --- > lib_ppc/board.c | 5 ++++- > 1 files changed, 4 insertions(+), 1 deletions(-) > > diff --git a/lib_ppc/board.c b/lib_ppc/board.c > index 3bcfb45..375b091 100644 > --- a/lib_ppc/board.c > +++ b/lib_ppc/board.c > @@ -339,10 +339,10 @@ init_fnc_t *init_sequence[] = { > #if defined(CONFIG_HARD_SPI) > init_func_spi, > #endif > +#ifdef CONFIG_POST > #if defined(CONFIG_DTT) /* Digital Thermometers and Thermostats */ > dtt_init, > #endif > -#ifdef CONFIG_POST > post_init_f, > #endif > INIT_FUNC_WATCHDOG_RESET > @@ -1072,6 +1072,9 @@ void board_init_r (gd_t *id, ulong dest_addr) > > WATCHDOG_RESET (); > > +#if defined(CONFIG_DTT) && !defined(CONFIG_POST) > + dtt_init (); > +#endif > #if defined(CONFIG_CMD_SCSI) > WATCHDOG_RESET (); > puts ("SCSI: "); Is there a reason we can't just move the dtt_init() call to after relocation to RAM for both the cases with and without CONFIG_POST defined? If some POST relies on the temperature sensors being initialized it seems cleaner to change the POST to run after relocation than add more ifdefery to common code. Unconditionally moving dtt_init() to after relocation would also allow dtt drivers to use global variables, etc (which it just so happens an lm90-type driver I'm working on requires:). Best, Peter