From: Paul Gortmaker Date: Sun, 20 Sep 2009 20:36:00 -0400 Subject: [U-Boot] [PATCH 0/6] sbc8548 update; remaining bits for 85xx tree. Message-ID: <1253493366-26427-1-git-send-email-paul.gortmaker@windriver.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de This is the remaining bits that weren't merged to 85xx, with the the requested fixes of course. Those being: sbc8548: correct local bus SDRAM size from 64M to 128M -now uses I/O accesors on BR4/OR4 sbc8548: update PCI/PCI-e support code -redone to make use of the code de-duplification effort. sbc8548: allow enabling PCI via a make config option -uses the "-t" to de-clutter the toplevel Makefile New patches are as follows: fsl_pci: create a SET_STD_PCI_INFO() helper wrapper -I believe this was meant to be created, but wasn't. sbc8548: use I/O accessors -uses the I/O accessors through the whole board file. sbc8548: remove eTSEC3/4 voltage hack -noticed this while doing above; sbc doesn't need it. Board still seems happy; I only noticed one cosmetic thing, that the new fsl_pci_init_port() prints "PCIE" always; even when the port is PCI and not PCI-e (see below). Thanks, Paul. U-Boot 2009.08-06732-g70c5c3d (Sep 20 2009 - 20:11:42) CPU: 8548E, Version: 2.0, (0x80390020) Core: E500, Version: 2.0, (0x80210020) Clock Configuration: CPU0:990 MHz, CCB:396 MHz, DDR:198 MHz (396 MT/s data rate), LBC:99 MHz L1: D-cache 32 kB enabled I-cache 32 kB enabled Board: Wind River SBC8548 Rev. 0x2 I2C: ready DRAM: Initializing SDRAM: 128 MB DDR: 256 MB FLASH: 72 MB L2: 512 KB enabled PCI host: 64 bit, 66 MHz, sync, arbiter Scanning PCI bus 00 00 01 8086 1026 0200 00 PCIE1 on bus 00 - 00 PCIE at base address e000a000 Scanning PCI bus 02 02 00 1148 9e00 0200 00 PCIE1 on bus 01 - 02 In: serial Out: serial Err: serial Net: eTSEC0, eTSEC1 =>