From: TsiChung Liew Date: Wed, 17 Mar 2010 20:39:26 -0500 Subject: [U-Boot] [PATCH 04/13] ColdFire: Relocate vector table - mcf5445x Message-ID: <1268876366-19479-1-git-send-email-tsicliew@gmail.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Newer ColdFire processors family boot from address 0 instead of 0xFFnn_nnnn. When the boot flash base chip select is set at new location instead of 0, an un-predictable error will occur if there is an vector being trigger and refer it to an invalid address or the vector table handler is not existed at address 0. Signed-off-by: TsiChung Liew --- cpu/mcf5445x/cpu_init.c | 9 +++++++++ 1 files changed, 9 insertions(+), 0 deletions(-) diff --git a/cpu/mcf5445x/cpu_init.c b/cpu/mcf5445x/cpu_init.c index 00e0ca6..8d51d35 100644 --- a/cpu/mcf5445x/cpu_init.c +++ b/cpu/mcf5445x/cpu_init.c @@ -28,6 +28,7 @@ #include #include #include +#include #include #if defined(CONFIG_CMD_NET) @@ -105,6 +106,14 @@ void cpu_init_f(void) fbcs->csmr5 = CONFIG_SYS_CS5_MASK; #endif + /* + * now the flash base address is no longer at 0 (Newer ColdFire family + * boot at address 0 instead of 0xFFnn_nnnn). The vector table must + * also move to the new location. + */ + if (CONFIG_SYS_CS0_BASE != 0) + setvbr(CONFIG_SYS_CS0_BASE); + #ifdef CONFIG_FSL_I2C gpio->par_feci2c = GPIO_PAR_FECI2C_SCL_SCL | GPIO_PAR_FECI2C_SDA_SDA; #endif -- 1.6.2.5