From: Guenter Roeck Date: Sun, 20 Jun 2010 19:19:32 +0000 Subject: [lm-sensors] [PATCH v2 0/3] hwmon: Driver for SMM665 Six-Channel Message-Id: <1277061575-13831-1-git-send-email-guenter.roeck@ericsson.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lm-sensors@vger.kernel.org This patchset adds support for the monitoring features of the Summit Microelectronics SMM665 Six-Channel Active DC Output Controller/Monitor. Issues/questions/notes: - Some of the command register defines are currently unused. Keep or remove ? - Critical/fault voltage limits are not supported by the current sysfs API, though available from the chip. Would it make sense to report those values, e.g. as inX_min_crit and inX_max_crit or inX_min_fault or inX_max_fault ? Note: This also applies to PMBus chips, so the question will come up again. - For four-channel chips, Channel E and F readings are reported, but undefined. Current approach is to mention this in the documentation. An alternative might be to create smm665_attributes dynamically. Any opinion which approach is better ? ------ v2 changes: - Added (untested) support for SMM465, SMM764, and SMM766. - Added vref module parameter to support non-default values of VREF_ADC. - Added an explanation describing what the chip does with _min and _max limit values. - Removed alarm sysfs files (since the chip does not report alarm status in a register, alarm detection was implemented by comparing limits with ADC readings, which can as well be done in userland). - Replaced register enums with defines. - Made limit variable names better readable. - Removed retries from smm665_read_adc(). - Check error reply from i2c_smbus_read_byte_data() and only accept ENXIO when expecting NACK. - Explained reason for byte swap after reading ADC registers in some more detail. - Added debug messages to display the error reason when reading ADC registers failed. _______________________________________________ lm-sensors mailing list lm-sensors@lm-sensors.org http://lists.lm-sensors.org/mailman/listinfo/lm-sensors