From: Christophe Varoqui Subject: Re: [PATCH] multipath: add find_multipaths feature. Date: Wed, 17 Nov 2010 00:51:15 +0100 Message-ID: <1289951475.3861.6.camel@zezette> References: <20101116232546.GU13763@ether.msp.redhat.com> Reply-To: christophe.varoqui@opensvc.com, device-mapper development Mime-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Return-path: In-Reply-To: <20101116232546.GU13763@ether.msp.redhat.com> List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Sender: dm-devel-bounces@redhat.com Errors-To: dm-devel-bounces@redhat.com To: device-mapper development List-Id: dm-devel.ids On mar., 2010-11-16 at 17:25 -0600, Benjamin Marzinski wrote: > This adds a new default feature, find_multipaths. When this is set to yes, > multipath will no longer try to create multipath devices using every > non-blacklisted device. Instead, it will only create a device when one of > three conditions are met. > > 1. Three are at least two non-blacklisted paths with the same wwid > 2. The user manually forces the creation, by specifying a device with the > multipath command. > 3. A path has the same wwid as a multipath device that was previously crreated > (even if that multipath device doesn't currently exist). I'm confused. A blacklist/whitelist system may be hard to configure properly but the rules are simple. I fear this new rule set will increase confusion. Could you elaborate on what problems this new rule set is trying to address ? Best regards, -- Christophe Varoqui OpenSVC