From: Stefano Babic Date: Wed, 9 May 2012 12:13:04 +0200 Subject: [U-Boot] [PATCH] MX5: PAD_CTL_DRV_VOT_LOW and PAD_CTL_DRV_VOT_HIGH exchanged Message-ID: <1336558384-17463-1-git-send-email-sbabic@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de After an update to the MX51 reference manual (Rev. 5), the values of the PAD_CTL_DRV_VOT_LOW and PAD_CTL_DRV_VOT_HIGH are now clearly wrong: "Bit 13: High / Low Output Voltage Range. This bit selects the output voltage mode for SD2_CMD. 0 High output voltage mode 1 Low output voltage mode" The values are currently negated in code - fixed. Reported-by: David Jander Signed-off-by: Stefano Babic CC: Marek Vasut CC: David Jander --- arch/arm/include/asm/arch-mx5/iomux.h | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/arch/arm/include/asm/arch-mx5/iomux.h b/arch/arm/include/asm/arch-mx5/iomux.h index 760371b..e3765a3 100644 --- a/arch/arm/include/asm/arch-mx5/iomux.h +++ b/arch/arm/include/asm/arch-mx5/iomux.h @@ -66,8 +66,8 @@ typedef enum iomux_pad_config { PAD_CTL_HYS_ENABLE = 0x1 << 8, /* Hysteresis enabled */ PAD_CTL_DDR_INPUT_CMOS = 0x0 << 9,/* DDR input CMOS */ PAD_CTL_DDR_INPUT_DDR = 0x1 << 9,/* DDR input DDR */ - PAD_CTL_DRV_VOT_LOW = 0x0 << 13, /* Low voltage mode */ - PAD_CTL_DRV_VOT_HIGH = 0x1 << 13,/* High voltage mode */ + PAD_CTL_DRV_VOT_LOW = 0x1 << 13, /* Low voltage mode */ + PAD_CTL_DRV_VOT_HIGH = 0x0 << 13,/* High voltage mode */ } iomux_pad_config_t; /* various IOMUX input functions */ -- 1.7.9.5