From: ryan@presslab.us (Ryan Press) Date: Thu, 28 Mar 2013 19:10:24 -0700 Subject: [PATCH] arm: mvebu: Add GPIO LEDs to Mirabox board Message-ID: <1364523024-20306-1-git-send-email-ryan@presslab.us> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Add the three external LED definitions to the device tree file on the Mirabox. The Mirabox user guide calls out one as a power LED, and the other two are defined for WiFi, but as the current mwifiex drivers don't have LED support, we make them status LEDs. These have been tested working by writing to the appropriate /sys/class/leds trigger. Signed-off-by: Ryan Press --- arch/arm/boot/dts/armada-370-mirabox.dts | 37 ++++++++++++++++++++++++++++++++ 1 file changed, 37 insertions(+) diff --git a/arch/arm/boot/dts/armada-370-mirabox.dts b/arch/arm/boot/dts/armada-370-mirabox.dts index dd0c57d..242796e 100644 --- a/arch/arm/boot/dts/armada-370-mirabox.dts +++ b/arch/arm/boot/dts/armada-370-mirabox.dts @@ -33,6 +33,43 @@ clock-frequency = <600000000>; status = "okay"; }; + + pinctrl { + pwr_led_pin: pwr-led-pin { + marvell,pins = "mpp63"; + marvell,function = "gpo"; + }; + + stat_led_pins: stat-led-pins { + marvell,pins = "mpp64", "mpp65"; + marvell,function = "gpio"; + }; + }; + + gpio_leds { + compatible = "gpio-leds"; + pinctrl-names = "default"; + pinctrl-0 = <&pwr_led_pin &stat_led_pins>; + + green_pwr_led { + label = "mirabox:green:pwr"; + gpios = <&gpio1 31 1>; + linux,default-trigger = "heartbeat"; + }; + + blue_stat_led { + label = "mirabox:blue:stat"; + gpios = <&gpio2 0 1>; + linux,default-trigger = "cpu0"; + }; + + green_stat_led { + label = "mirabox:green:stat"; + gpios = <&gpio2 1 1>; + default-state = "off"; + }; + }; + mdio { phy0: ethernet-phy at 0 { reg = <0>; -- 1.8.1.2