From: Fabio Estevam Date: Fri, 3 May 2013 15:07:57 -0300 Subject: [U-Boot] [PATCH 1/6] README: mx28_common: Keep the text within 80 columns Message-ID: <1367604482-20955-1-git-send-email-festevam@gmail.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de From: Fabio Estevam In order to improve readability keep the text within 80 columns. Signed-off-by: Fabio Estevam --- doc/README.mx28_common | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-) diff --git a/doc/README.mx28_common b/doc/README.mx28_common index 8bacaf8..6618908 100644 --- a/doc/README.mx28_common +++ b/doc/README.mx28_common @@ -63,9 +63,9 @@ means "/usr/local/bin/" has to be in your $PATH. 2) Compiling U-Boot for a MX28 based board ------------------------------------------- -Compiling the U-Boot for a MX28 board is straightforward and done as compiling U-Boot -for any other ARM device. For cross-compiler setup, please refer to ELDK5.0 -documentation. First, clean up the source code: +Compiling the U-Boot for a MX28 board is straightforward and done as compiling +U-Boot for any other ARM device. For cross-compiler setup, please refer to +ELDK5.0 documentation. First, clean up the source code: $ make mrproper @@ -150,8 +150,8 @@ NOTE: If the user needs to adjust the start sector, the "mxsboot" tool contains 4) Installation of U-Boot into NAND flash ----------------------------------------- -To boot a MX28 based board from NAND, set the boot mode DIP switches according to i.MX28 -manual chapter 12.2.1 (Table 12-2), PORT=GPMI, NAND 1.8 V. +To boot a MX28 based board from NAND, set the boot mode DIP switches according +to i.MX28 manual chapter 12.2.1 (Table 12-2), PORT=GPMI, NAND 1.8 V. There are two possibilities when preparing an image writable to NAND flash. -- 1.7.9.5