From: Scott Wood Date: Wed, 2 Oct 2013 17:03:17 -0500 Subject: [U-Boot] [PATCH 1/1] am33xx: add CONFIG_SYS_NAND_DEVICE_WIDTH to determine NAND device bus-width In-Reply-To: <20980858CB6D3A4BAE95CA194937D5E73EA1901F@DBDE04.ent.ti.com> References: <1380086306-17046-1-git-send-email-pekon@ti.com> <1380147408.24959.202.camel@snotra.buserror.net> <20980858CB6D3A4BAE95CA194937D5E73EA16E87@DBDE04.ent.ti.com> <1380223782.24959.280.camel@snotra.buserror.net> <20980858CB6D3A4BAE95CA194937D5E73EA1726A@DBDE04.ent.ti.com> <1380316123.24959.480.camel@snotra.buserror.net> <20980858CB6D3A4BAE95CA194937D5E73EA17A1E@DBDE04.ent.ti.com> <1380656566.10618.45.camel@snotra.buserror.net> <20980858CB6D3A4BAE95CA194937D5E73EA1901F@DBDE04.ent.ti.com> Message-ID: <1380751397.12932.118.camel@snotra.buserror.net> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Wed, 2013-10-02 at 14:40 +0000, Gupta, Pekon wrote: > Hi, > > Please see last set of queries inline.. > > > From: Scott Wood [mailto:scottwood at freescale.com] > > > On Sat, 2013-09-28 at 06:24 +0000, Gupta, Pekon wrote: > > > > From: Scott Wood [mailto:scottwood at freescale.com] > > > > > On Fri, 2013-09-27 at 04:18 +0000, Gupta, Pekon wrote: > [snip] > > > > > > > (1) drivers/mtd/nand/fsl_ifc_spl.c > > > (2) drivers/mtd/nand/fsl_elbc_spl.c > > > So CONFIG_SYS_NAND_DEVICE_WIDTH should help them also. right ? > > > > How would it help? > > > I meant, instead of requiring the modification in board file, > CONFIG_SPL_DEVICE_WIDTH can be put in include/configs/*.h Those registers are already specified in include/configs/*.h for eLBC/IFC. > > > So can this new CONFIG_xx be accepted ? > > > > Only for SPL usage. > > > Ok. so should I rename to CONFIG_SPL_NAND_DEVICE_WIDTH ? In theory yes, though the other similar SPL NAND parameters use CONFIG_SYS. -Scott