From: =?UTF-8?q?Andreas=20Bie=C3=9Fmann?= Date: Mon, 9 Dec 2013 13:39:49 +0100 Subject: [U-Boot] =?utf-8?q?=5BU-Boot=2C_v3=5D_arm=3A_at91=3A_support_for_?= =?utf-8?q?the_Calao_USB-A9263_board_=28based_on_AT91SAM9263=29?= In-Reply-To: <1386023458-16608-1-git-send-email-mateusz.kulikowski@gmail.com> from Mateusz Kulikowski on Mon, 2 Dec 2013 23:30:58 +0100 References: <1386023458-16608-1-git-send-email-mateusz.kulikowski@gmail.com> Message-ID: <1386592789-12357-1-git-send-email-andreas.devel@googlemail.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear Mateusz Kulikowski, Mateusz Kulikowski writes: >Add support for USB-A9263 board manufactured by Calao Systems >(http://www.calao-systems.com/). >Code is based on old U-Boot sources (2010.09) released by Calao. > >Signed-off-by: Mateusz Kulikowski > >--- >Changes for v3 >- Updated Makefile to a new build system >- Use generic GPIO for NAND and MAC (requires new GPIO patches) >- Use common at91 phy reset >- Dropped spi0 clock setup (pin is unused) >- Fixed PHY address as 0x0001 and dropped PHY autodetect > (no need for autodetect - PHY address is bootstrapped to 1) >--- > board/calao/usb_a9263/Makefile | 14 ++++ > board/calao/usb_a9263/usb_a9263.c | 148 +++++++++++++++++++++++++++++++++ > boards.cfg | 1 + > include/configs/usb_a9263.h | 169 ++++++++++++++++++++++++++++++++++++++ > 4 files changed, 332 insertions(+) > create mode 100644 board/calao/usb_a9263/Makefile > create mode 100644 board/calao/usb_a9263/usb_a9263.c > create mode 100644 include/configs/usb_a9263.h applied to u-boot-atmel/master, thanks! Best regards, Andreas Bie?mann