From: Tom Rini Date: Fri, 18 Jul 2014 11:51:32 -0400 Subject: [U-Boot] [PATCH v3 2/5] TI:armv7: Change CONFIG_SPL_STACK to not be CONFIG_SYS_INIT_SP_ADDR In-Reply-To: <1405698695-19730-1-git-send-email-trini@ti.com> References: <1405698695-19730-1-git-send-email-trini@ti.com> Message-ID: <1405698695-19730-2-git-send-email-trini@ti.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de There are times where we may need more than a few kilobytes of stack space. We also will not be using CONFIG_SPL_STACK location prior to DDR being initialized (CONFIG_SYS_INIT_SP_ADDR is still used there) so pick a good location within DDR for this to be. Tested on OMAP4/AM335x/OMAP5/DRA7xx. Signed-off-by: Tom Rini --- Changes in v3: - Change CONFIG_SPL_STACK to CONFIG_SYS_SDRAM_BASE + 32MB, reword comment --- include/configs/ti_armv7_common.h | 19 +++++++++++-------- 1 file changed, 11 insertions(+), 8 deletions(-) diff --git a/include/configs/ti_armv7_common.h b/include/configs/ti_armv7_common.h index 6e0bf09..9f4ba5e 100644 --- a/include/configs/ti_armv7_common.h +++ b/include/configs/ti_armv7_common.h @@ -203,15 +203,18 @@ #define CONFIG_SPL_OS_BOOT /* - * Place the image at the start of the ROM defined image space. - * We limit our size to the ROM-defined downloaded image area, and use the - * rest of the space for stack. We load U-Boot itself into memory at - * 0x80800000 for legacy reasons (to not conflict with older SPLs). We - * have our BSS be placed 1MiB after this, to allow for the default - * Linux kernel address of 0x80008000 to work, in the Falcon Mode case. - * We have the SPL malloc pool at the end of the BSS area. + * Place the image at the start of the ROM defined image space (per + * CONFIG_SPL_TEXT_BASE and we limit our size to the ROM-defined + * downloaded image area. We initalize DRAM as soon as we can so that + * we can place stack, malloc and BSS there. We load U-Boot itself into + * memory at 0x80800000 for legacy reasons (to not conflict with older + * SPLs). We have our BSS be placed 2MiB after this, to allow for the + * default Linux kernel address of 0x80008000 to work with most sized + * kernels, in the Falcon Mode case. We have the SPL malloc pool at the + * end of the BSS area. We place our stack at 32MiB after the start of + * DRAM to allow room for all of the above. */ -#define CONFIG_SPL_STACK CONFIG_SYS_INIT_SP_ADDR +#define CONFIG_SPL_STACK (CONFIG_SYS_SDRAM_BASE + (32 << 20)) #ifndef CONFIG_SYS_TEXT_BASE #define CONFIG_SYS_TEXT_BASE 0x80800000 #endif -- 1.7.9.5