From: Tony Lindgren Subject: [PATCH 0/5] Clean-up for twl4030-usb Date: Wed, 27 Aug 2014 16:28:06 -0700 Message-ID: <1409182091-31191-1-git-send-email-tony@atomide.com> Return-path: Sender: linux-kernel-owner@vger.kernel.org To: kishon@ti.com Cc: balbi@ti.com, linux-kernel@vger.kernel.org, linux-usb@vger.kernel.org, linux-omap@vger.kernel.org List-Id: linux-omap@vger.kernel.org Hi, Here are few more patches for v3.18 to clean up twl4030-usb. These are based on the two regression fixes I sent earlier: [PATCH] usb: phy: twl4030-usb: Fix regressions to runtime PM on omaps [PATCH] usb: phy: twl4030-usb: Fix lost interrupts after ID pin goes down For testing with v3.17-rc2, you probably also want to revert commit a9232076374334ca2bc2a448dfde96d38a54349a until that hits the mainline tree. And you may also want to apply the following patch if testing with PM: [PATCH] mfd: twl4030-power: Fix PM idle pin configuration to not conflict with regulators I've also pushed these patches with the optional patches into a temporary testing branch at [1]. Regards, Tony [1] git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap.git omap-for-v3.17/testing-pending-usb Tony Lindgren (5): usb: phy: twl4030-usb: Remove unused irq_enabled usb: phy: twl4030-usb: Simplify phy init to use runtime PM usb: phy: twl4030-usb: Move code from twl4030_phy_power to the runtime PM calls usb: phy: twl4030-usb: Remove asleep and rely on runtime PM usb: phy: twl4030-usb: Use mutex instead of spinlock for protecting the data drivers/phy/phy-twl4030-usb.c | 124 ++++++++++++++------------------------ drivers/usb/phy/phy-twl6030-usb.c | 2 - 2 files changed, 46 insertions(+), 80 deletions(-) -- 1.8.1.1