From: Kamil Debski Date: Mon, 03 Nov 2014 14:42:55 +0000 Subject: [lm-sensors] [PATCH] hwmon: (pwm-fan) Fix suspend/resume behavior Message-Id: <1415025775-24237-1-git-send-email-k.debski@samsung.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: linux-kernel@vger.kernel.org, lm-sensors@lm-sensors.org Cc: linux@roeck-us.net, Kamil Debski The state of a PWM output is not clearly defined after resume. Some PWM drivers do not restore the duty cycle upon resume, thus it is necessary to manually restore the correct value. Signed-off-by: Kamil Debski --- drivers/hwmon/pwm-fan.c | 13 ++++++++++--- 1 file changed, 10 insertions(+), 3 deletions(-) diff --git a/drivers/hwmon/pwm-fan.c b/drivers/hwmon/pwm-fan.c index 823c877..1991d903 100644 --- a/drivers/hwmon/pwm-fan.c +++ b/drivers/hwmon/pwm-fan.c @@ -161,10 +161,17 @@ static int pwm_fan_suspend(struct device *dev) static int pwm_fan_resume(struct device *dev) { struct pwm_fan_ctx *ctx = dev_get_drvdata(dev); + unsigned long duty; + int ret; - if (ctx->pwm_value) - return pwm_enable(ctx->pwm); - return 0; + if (ctx->pwm_value = 0) + return 0; + + duty = DIV_ROUND_UP(ctx->pwm_value * (ctx->pwm->period - 1), MAX_PWM); + ret = pwm_config(ctx->pwm, duty, ctx->pwm->period); + if (ret) + return ret; + return pwm_enable(ctx->pwm); } #endif -- 1.7.9.5 _______________________________________________ lm-sensors mailing list lm-sensors@lm-sensors.org http://lists.lm-sensors.org/mailman/listinfo/lm-sensors