From: Bartosz Golaszewski Date: Fri, 19 Dec 2014 09:36:07 +0000 Subject: [lm-sensors] [RESEND PATCH v7 3/5] hwmon: ina2xx: don't accept shunt values greater than the calibra Message-Id: <1418981769-11287-4-git-send-email-bgolaszewski@baylibre.com> List-Id: References: <1418981769-11287-1-git-send-email-bgolaszewski@baylibre.com> In-Reply-To: <1418981769-11287-1-git-send-email-bgolaszewski@baylibre.com> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: Guenter Roeck Cc: LKML , Benoit Cousson , Patrick Titiano , LM Sensors , Bartosz Golaszewski Shunt resistance values greater than the chip's calibration factor make no sense since the actual value written to the register equals: / Bail-out from ina2xx_probe() if the configured value is greater than the calibration factor. Signed-off-by: Bartosz Golaszewski --- drivers/hwmon/ina2xx.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/drivers/hwmon/ina2xx.c b/drivers/hwmon/ina2xx.c index 39e017b..3234e57 100644 --- a/drivers/hwmon/ina2xx.c +++ b/drivers/hwmon/ina2xx.c @@ -313,7 +313,8 @@ static int ina2xx_probe(struct i2c_client *client, data->config = &ina2xx_config[data->kind]; data->client = client; - if (data->rshunt <= 0) + if (data->rshunt <= 0 || + data->rshunt > data->config->calibration_factor) return -ENODEV; ret = ina2xx_init(data); -- 2.1.3 _______________________________________________ lm-sensors mailing list lm-sensors@lm-sensors.org http://lists.lm-sensors.org/mailman/listinfo/lm-sensors