From: Bartosz Golaszewski Date: Mon, 05 Jan 2015 14:20:51 +0000 Subject: [lm-sensors] [PATCH v8 0/5] hwmon: ina2xx: implement chip reinitialization and add new attributes Message-Id: <1420467656-6112-1-git-send-email-bgolaszewski@baylibre.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: Guenter Roeck Cc: LKML , Benoit Cousson , Patrick Titiano , LM Sensors , Bartosz Golaszewski This series implements a mechanism to detect if the chip is in its POR state and reinitialize it if needed. It also extends the sysfs interface to make the driver configurable at run-time. The shunt_resistor attribute allows to change the shunt resistance value at run-time in cases where ina2xx used to do the measurement isn't integrated with the shunt. The avg_rate attribute allows to increase/decrease noise reduction. v8: - accept averaging rate values more flexibly and round them to the nearest correct value - don't call ina2xx_update_device() in ina226_set_avg() - make sure the registers are going to be re-read after setting the averaging rate v7: https://www.mail-archive.com/linux-kernel%40vger.kernel.org/msg787851.html Bartosz Golaszewski (5): hwmon: ina2xx: reinitialize the chip in case it's been reset hwmon: ina2xx: remove a stray new line hwmon: ina2xx: don't accept shunt values greater than the calibration factor hwmon: ina2xx: make shunt resistance configurable at run-time hwmon: ina2xx: allow to change the averaging rate at run-time Documentation/hwmon/ina2xx | 8 +- drivers/hwmon/ina2xx.c | 301 +++++++++++++++++++++++++++++++++++++++------ 2 files changed, 266 insertions(+), 43 deletions(-) -- 2.1.3 _______________________________________________ lm-sensors mailing list lm-sensors@lm-sensors.org http://lists.lm-sensors.org/mailman/listinfo/lm-sensors