From: DaveKucharczyk Date: Thu, 26 Feb 2015 07:19:38 -0700 (MST) Subject: [U-Boot] U-Boot stuck after relocation attempt on MX51 board In-Reply-To: References: <1424830787325-206738.post@n7.nabble.com> <1424899387250-206846.post@n7.nabble.com> <1424902136989-206862.post@n7.nabble.com> Message-ID: <1424960378795-206924.post@n7.nabble.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Beno?t Th?baudeau-2 wrote > Also, check the CONFIG_SYS_TEXT_BASE of your board. From your log, I'm > wondering if it's not set too high, resulting in an overlap of the > pre- and post-relocation addresses occupied by your binary in the > 256-MiB case. BINGO!!! Good catch Beno?t, thank you. I changed it from 9FF80000 to 9F000000 and now it boots. Looking at the original log...it relocated 90KB above text base. Not quite enough room... -------- U-Boot code: 9FF80000 -> 9FFA6840 BSS: -> 9FFD944C . Relocating to 9ff96000, new gd at 9fe55ed0, sp at 9fe55eb0 ------ On a side note, how involved would it be to convert to 2015.01? I've already ported 3 boards for 2014.07. Will everything I've done work perfectly fine with 2015.01? -- View this message in context: http://u-boot.10912.n7.nabble.com/U-Boot-stuck-after-relocation-attempt-on-MX51-board-tp206738p206924.html Sent from the U-Boot mailing list archive at Nabble.com.