From: Catherine Sullivan Date: Mon, 28 Sep 2015 14:12:40 -0400 Subject: [Intel-wired-lan] [next PATCH S16 11/15] i40evf: correctly populate vlan_features In-Reply-To: <1443463964-148204-1-git-send-email-catherine.sullivan@intel.com> References: <1443463964-148204-1-git-send-email-catherine.sullivan@intel.com> Message-ID: <1443463964-148204-12-git-send-email-catherine.sullivan@intel.com> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: intel-wired-lan@osuosl.org List-ID: From: Mitch Williams The vlan_features field was correctly being set to the same value as the netdev features field. However, this was being done before the features were actually being set up, leaving the vlan_features empty. Also, after a reset, vlan_features will be incorrectly assigned the previous netdev feature flags, which can contain VLAN feature bits. This makes the VLAN code angry and will cause a stack dump. To fix these issues, set up the netdev features first, then mask out the VLAN feature bits when assigning vlan_features. Signed-off-by: Mitch Williams Change-ID: Ib0548869dc83cf6a841cb8697dd94c12359ba4d2 --- drivers/net/ethernet/intel/i40evf/i40evf_main.c | 5 ++++- 1 file changed, 4 insertions(+), 1 deletion(-) diff --git a/drivers/net/ethernet/intel/i40evf/i40evf_main.c b/drivers/net/ethernet/intel/i40evf/i40evf_main.c index 5e13363..9e754d0 100644 --- a/drivers/net/ethernet/intel/i40evf/i40evf_main.c +++ b/drivers/net/ethernet/intel/i40evf/i40evf_main.c @@ -2123,7 +2123,10 @@ int i40evf_process_config(struct i40evf_adapter *adapter) if (adapter->vf_res->vf_offload_flags & I40E_VIRTCHNL_VF_OFFLOAD_VLAN) { - netdev->vlan_features = netdev->features; + netdev->vlan_features = netdev->features & + ~(NETIF_F_HW_VLAN_CTAG_TX | + NETIF_F_HW_VLAN_CTAG_RX | + NETIF_F_HW_VLAN_CTAG_FILTER); netdev->features |= NETIF_F_HW_VLAN_CTAG_TX | NETIF_F_HW_VLAN_CTAG_RX | NETIF_F_HW_VLAN_CTAG_FILTER; -- 1.9.3