From: Eugen.Hristev at microchip.com Date: Wed, 8 May 2019 12:58:19 +0000 Subject: [U-Boot] [PATCH 2/3] board: atmel: sama5d2_icp: standby disable on CAN transceivers in SPL In-Reply-To: <1557320006-5768-1-git-send-email-eugen.hristev@microchip.com> References: <1557320006-5768-1-git-send-email-eugen.hristev@microchip.com> Message-ID: <1557320006-5768-2-git-send-email-eugen.hristev@microchip.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de From: Eugen Hristev The 2 CAN transceivers have a STBDY pin which must be low in order to operate. This pin is tied to PB25. Set it to 0 in bootstrap. At a later time, this needs to be controlled by Linux power management system, or requested by some driver as a gpio and tied to 0 during CAN link up. Signed-off-by: Eugen Hristev --- board/atmel/sama5d2_icp/sama5d2_icp.c | 7 +++++++ 1 file changed, 7 insertions(+) diff --git a/board/atmel/sama5d2_icp/sama5d2_icp.c b/board/atmel/sama5d2_icp/sama5d2_icp.c index 1c28aab..f55ea2c 100644 --- a/board/atmel/sama5d2_icp/sama5d2_icp.c +++ b/board/atmel/sama5d2_icp/sama5d2_icp.c @@ -73,6 +73,12 @@ int misc_init_r(void) /* SPL */ #ifdef CONFIG_SPL_BUILD +/* must set PB25 low to enable the CAN transceivers */ +static void board_can_stdby_dis(void) +{ + atmel_pio4_set_pio_output(AT91_PIO_PORTB, 25, 0); +} + /* deassert reset lines for external periph in case of warm reboot */ static void board_reset_additional_periph(void) { @@ -111,6 +117,7 @@ void spl_board_init(void) spl_mmc_init(); #endif board_reset_additional_periph(); + board_can_stdby_dis(); } void spl_display_print(void) -- 2.7.4