From: Eugen.Hristev at microchip.com Date: Wed, 8 May 2019 12:58:20 +0000 Subject: [U-Boot] [PATCH 3/3] board: atmel: sama5d2_icp: enable green led on SPL completion In-Reply-To: <1557320006-5768-1-git-send-email-eugen.hristev@microchip.com> References: <1557320006-5768-1-git-send-email-eugen.hristev@microchip.com> Message-ID: <1557320006-5768-3-git-send-email-eugen.hristev@microchip.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de From: Eugen Hristev Enable the green led on SPL completion. Red led has no pulldown and it will be lighted by default when the board starts up. If the PMIC is not configured to enable LDO2, the leds will not light. Signed-off-by: Eugen Hristev --- board/atmel/sama5d2_icp/sama5d2_icp.c | 8 ++++++++ 1 file changed, 8 insertions(+) diff --git a/board/atmel/sama5d2_icp/sama5d2_icp.c b/board/atmel/sama5d2_icp/sama5d2_icp.c index f55ea2c..1593e2b 100644 --- a/board/atmel/sama5d2_icp/sama5d2_icp.c +++ b/board/atmel/sama5d2_icp/sama5d2_icp.c @@ -79,6 +79,13 @@ static void board_can_stdby_dis(void) atmel_pio4_set_pio_output(AT91_PIO_PORTB, 25, 0); } +static void board_leds_init(void) +{ + atmel_pio4_set_pio_output(AT91_PIO_PORTB, 0, 0); /* RED */ + atmel_pio4_set_pio_output(AT91_PIO_PORTB, 1, 1); /* GREEN */ + atmel_pio4_set_pio_output(AT91_PIO_PORTA, 31, 0); /* BLUE */ +} + /* deassert reset lines for external periph in case of warm reboot */ static void board_reset_additional_periph(void) { @@ -118,6 +125,7 @@ void spl_board_init(void) #endif board_reset_additional_periph(); board_can_stdby_dis(); + board_leds_init(); } void spl_display_print(void) -- 2.7.4