From: Kamal Dasu Subject: [PATCH v3 1/2] dt-bindings: mtd: brcmnand: Make nand-ecc-strength and nand-ecc-step-size optional Date: Tue, 21 May 2019 10:44:21 -0400 Message-ID: <1558449865-36852-1-git-send-email-kdasu.kdev@gmail.com> Return-path: Sender: linux-kernel-owner@vger.kernel.org To: linux-mtd@lists.infradead.org Cc: bcm-kernel-feedback-list@broadcom.com, linux-kernel@vger.kernel.org, Kamal Dasu , David Woodhouse , Brian Norris , Marek Vasut , Miquel Raynal , Richard Weinberger , Vignesh Raghavendra , Rob Herring , Mark Rutland , devicetree@vger.kernel.org List-Id: devicetree@vger.kernel.org nand-ecc-strength and nand-ecc-step-size can be made optional as brcmnand driver can support using raw NAND layer detected values. Signed-off-by: Kamal Dasu --- Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt b/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt index bcda1df..0d952af 100644 --- a/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt +++ b/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt @@ -101,12 +101,12 @@ Required properties: number (e.g., 0, 1, 2, etc.) - #address-cells : see partition.txt - #size-cells : see partition.txt -- nand-ecc-strength : see nand.txt -- nand-ecc-step-size : must be 512 or 1024. See nand.txt Optional properties: +- nand-ecc-strength : see nand-controller.yaml +- nand-ecc-step-size : must be 512 or 1024. See nand-controller.yaml - nand-on-flash-bbt : boolean, to enable the on-flash BBT for this - chip-select. See nand.txt + chip-select. See nand-controller.yaml - brcm,nand-oob-sector-size : integer, to denote the spare area sector size expected for the ECC layout in use. This size, in addition to the strength and step-size, -- 1.9.0.138.g2de3478