From: Mark-MC.Lee Date: Mon, 15 Jun 2020 15:19:30 +0800 Subject: [U-boot,1/2] eth: mtk-eth: enable mt7629 sgmii mode support in mediatek eth driver In-Reply-To: References: <20200527112506.2919-1-Mark-MC.Lee@mediatek.com> <20200527112506.2919-2-Mark-MC.Lee@mediatek.com> Message-ID: <1592205570.22827.4.camel@mtksdccf07> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Sun, 2020-05-31 at 08:08 -0600, Simon Glass wrote: > Hi MarkLee, > > On Wed, 27 May 2020 at 05:25, MarkLee wrote: > > > > The sgmii mode init flow is almost the same for all mediatek SoC, the > > only difference is the register offset(SGMSYS_GEN2_SPEED) is 0x2028 > > for old chip(mt7622) but changed to 0x128 for newer chip(mt7629 and > > the following chips). > > > > Signed-off-by: MarkLee > > --- > > drivers/net/mtk_eth.h | 5 +++++ > > 1 file changed, 5 insertions(+) > > > > diff --git a/drivers/net/mtk_eth.h b/drivers/net/mtk_eth.h > > index f2940c9996..3c85eab91a 100644 > > --- a/drivers/net/mtk_eth.h > > +++ b/drivers/net/mtk_eth.h > > @@ -44,7 +44,12 @@ > > #define SGMSYS_QPHY_PWR_STATE_CTRL 0xe8 > > #define SGMII_PHYA_PWD BIT(4) > > > > +#if defined(CONFIG_TARGET_MT7622) > > #define SGMSYS_GEN2_SPEED 0x2028 > > +#else > > +#define SGMSYS_GEN2_SPEED 0x128 > > +#endif > > You can't check #ifdefs in drivers. You should use a compatible > string, then device_get_driver_data() to decide what the value is > here. Thanks for your review and suggestion, will change to use private data from dts to decide the value in the following V2 patch. > > Or if this is board-specific you could add it to the device-tree node > as a property, if it is in the binding. > > Regards, > Simon