Return-Path: Message-Id: <199902041101.MAA13345@be3334.schering.de> From: "Strelow, Ulrich" To: hppa-linux@puffingroup.com Date: Thu, 4 Feb 1999 11:59:00 +0100 MIME-Version: 1.0 Content-Type: text/plain Subject: [hppa-linux] Cross compile setup Resent-Message-ID: <"vzIO_.0.Bs6.MWPks"@burrow.puffingroup.com> Reply-To: hppa-linux@puffingroup.com List-Id: linux-parisc.vger.kernel.org Hi, I am very interested that someone finally tries to do a native port of Linux for PA-RISC. At work I have an old HP 715/33 workstation (the *one* machine that is not supported by mk-linux) which I would like to run linux on. OSF has never managed to get the mach kernel booting on that box and my question about the problems were answered that is has something to do with the ethernet chip. Some months ago I tried to cross-compile the mach-kernel under Linux-x86. For private purposes I have bought a SCSI-MOD-drive which serves as the data transfer media between my home PC running linux and the HP 715/33 at work. I was not very successful with that cross-compiled mach-kernel. After booting the only messages I saw were from the secondary boot loader: OSF Mach boot [/mach]: -a text (0x11000) at 0x11000 data (0x92610) at 0x5 Then the machine stops with the LEDs 123568 on which means "HPMC due to Bus Error". Unfortunately no one on the mklinux mailing list had any help for that problem (probably because the main developers were no longer working on/with mk-linux). So my question here is the following: Is the hppa-linux cross-compile setup for binutils and egcs possible from linux-x86 ? If yes I would like to take part on the project as an "early pre-alpha stage"-tester :) in case you need one. Ulrich ---------------------- Ulrich Strelow Berlin, Germany ---------------------------------------------------------------------- To unsubscribe: send e-mail to hppa-linux-request@puffingroup.com with `unsubscribe' as the subject.