From: Paul Davis Subject: Re: Rawmidi bug or missed feature? Date: Fri, 01 Mar 2002 08:45:49 -0500 Message-ID: <200203011345.IAA12541@renoir.op.net> In-reply-to: Your message of "Thu, 28 Feb 2002 23:56:35 +0100." <3C7EB5A2.335E82C4@ufh.se> Errors-To: alsa-devel-admin@lists.sourceforge.net List-Help: List-Post: List-Subscribe: , List-Unsubscribe: , List-Archive: To: Peter Enderborg Cc: "alsa-devel@lists.sourceforge.net" List-Id: alsa-devel@alsa-project.org >I have a program that read's from a raw midi device. In midi there >are some simple compression. It is assumed that if the data flow is >correct, and the data should be interpreted as paramaters to previus >command if it's not a new command. But when I open a raw midi stream >I can get in to the stream without having the "previus" command. Is >there any way to do a query or reset the stream so I can get that >command? If it's only one midi channel sending the same type of >command it will never get in to sync! raw MIDI means ***RAW*** MIDI. there is no parsing, no state, no history, no automatic reset. you just read and write a stream of bytes. it sounds as if you should issue a full MIDI reset sequence when you open the device (all notes off on every channel, reset all controllers to a default value, restore all programs to a known state, etc.) --p _______________________________________________ Alsa-devel mailing list Alsa-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/alsa-devel