From: Paul Davis Subject: ALSA Hammerfall DSP driver Date: Mon, 13 May 2002 21:33:32 -0400 Sender: alsa-devel-admin@lists.sourceforge.net Message-ID: <200205140133.g4E1XWJ32168@op.net> Reply-To: alsa-devel@alsa-project.org Return-path: Received: from newmx1.fast.net (newmx1.fast.net [209.92.1.31]) by alsa.alsa-project.org (8.9.3/8.9.3/SuSE Linux 8.9.3-0.1) with ESMTP id DAA17628 for ; Tue, 14 May 2002 03:32:24 +0200 Received: from unknown (HELO op.net) ([209.92.100.30]) (envelope-sender ) by newmx1.fast.net (qmail-ldap-1.03) with SMTP for ; 14 May 2002 01:32:21 -0000 Errors-To: alsa-devel-admin@lists.sourceforge.net List-Help: List-Post: List-Subscribe: , List-Unsubscribe: , List-Archive: To: alsa-devel@alsa-project.org, linux-audio-announce@music.columbia.edu List-Id: alsa-devel@alsa-project.org I'm pleased to announce that ALSA now has support for the Hammerfall DSP audio interface. Details of the Hammerfall DSP are available at RME's website (www.rme-audio.com). The driver supports: * all sample rates * both MIDI ports * "simple mixer" controls to allow alsamixer to control each playback stream's volume. Remember: as usual with ALSA, the initial state is "all output muted". * peak meters for input, output and playback, with serial clipping counters. * a non-standard control element for the matrix mixer (this may change; do not plan long term application support around it) Things that are not tested but should work: * big-endian systems * multiface i/o box * cardbus interface * different sample clock sync sources Things that don't work: * RMS meters * Flashing the firmware into the I/O box The driver is similar in some ways the Hammerfall driver. Most notably, it requires large chunks of physically contiguous memory. This is best provided for by loading the snd-hammerfall-mem module early during booting, which provides memory for both Hammerfall and Hammerfall DSP drivers. The module has a snd-enable option which takes a comma-separated list of 0's or 1's indicating whether or not to allocate memory for the n'th Hammerfall or Hammerfall DSP device. If you have only once such device, then snd-enable=1 will be sufficient. The module checks for installed devices, so you can always insert the module and the right thing will happen even if you have removed your Hammerfall/Hammerfall DSP cards. I am sure there will be minor glitches along the way. I would really appreciate feedback from anyone with an H-DSP (marcus - that means you! :) A huge thank you to RME for the foresight and sense to make available sufficient information to make this driver possible. --p _______________________________________________________________ Have big pipes? SourceForge.net is looking for download mirrors. We supply the hardware. You get the recognition. Email Us: bandwidth@sourceforge.net