From: Bruno Ducrot Subject: Re: Pentium III Coppermine and 440BX/ZX/DX Date: Tue, 17 Feb 2004 10:54:11 +0100 Sender: cpufreq-bounces@www.linux.org.uk Message-ID: <20040217095411.GV13262@poupinou.org> References: <20040217005504.GA809@acheron.utfors.se> Mime-Version: 1.0 Return-path: Content-Disposition: inline In-Reply-To: <20040217005504.GA809@acheron.utfors.se> List-Id: List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Errors-To: cpufreq-bounces+glkc-cpufreq=gmane.org@www.linux.org.uk Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: cpufreq@www.linux.org.uk On Tue, Feb 17, 2004 at 01:55:04AM +0100, Jesper Anderson wrote: > I have a Gateway Solo 3450 laptop, which is a PIII 750 MHz with a > PIIX4 chipset. I'm trying to get both ACPI and cpufreq to work on it, > with very little luck so far. The ACPI is its own kettel of fish, I > suspect the BIOS might be rather broken (but then, which isn't?), but > I was hoping the cpufreq issue could at least be somewhat easy to > solve. > > Unfortunately I'm a bit unclear on just what I need to do to get > cpufreq running on this system. I tried modprobing speedstep-smi (from > kernel 2.6.2 with mm1), and it gives no errors - but neither does it > give me anything to go on in /sys or /proc. speedstep-ich doesn't load > at all. I tried the patch posted previously on the mailing list (that > removes a few bits of the PIII check), but that didn't make any > difference. > > I'm a bit at a loss as to where to go from here. speedstep-detect > doesn't show any different output on battery or AC power, can that be > a problem? > > Output of speedstep-detect is attached. > > Thanks in advance, > > Jesper > > > # ./speedstep-detect > dmi_scan: return: > DMI present. > 31 structures occupying 1004 bytes. > DMI table at 0x000D3010. > BIOS Vendor: Gateway > BIOS Version: 28.06.04 > BIOS Release: 03/14/2002 > System Vendor: Gateway > Product Name: Solo3450 > Version: Rev 1.0 > Board Vendor: Gateway > Board Name: Solo3450 > Board Version: Rev 1.0 > Trying Intel's int15 GSIC: > BIOS support GSIC call: > signature: GSIC > command port = 0x00b2 > command = 0x0080 > event port = 0x000000b3 > flags = 0x07d00100 There is good chance that it work, but I think that you need to pass the smi_cmd=0x82 to speedstep-smi: modprobe speedstep-smi smi_cmd=0x82 Cheers, -- Bruno Ducrot -- Which is worse: ignorance or apathy? -- Don't know. Don't care.