From: Jesper Anderson Subject: Re: Pentium III Coppermine and 440BX/ZX/DX Date: Tue, 17 Feb 2004 17:27:20 +0100 Sender: cpufreq-bounces@www.linux.org.uk Message-ID: <20040217162720.GA1202@acheron.utfors.se> References: <20040217005504.GA809@acheron.utfors.se> <20040217095411.GV13262@poupinou.org> Mime-Version: 1.0 Return-path: Content-Disposition: inline In-Reply-To: <20040217095411.GV13262@poupinou.org> List-Id: List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Errors-To: cpufreq-bounces+glkc-cpufreq=gmane.org@www.linux.org.uk Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: Bruno Ducrot Cc: cpufreq@www.linux.org.uk On Tue, Feb 17, 2004 at 10:54:11AM +0100, Bruno Ducrot wrote: > > There is good chance that it work, but I think that you need to pass the > smi_cmd=0x82 to speedstep-smi: > > modprobe speedstep-smi smi_cmd=0x82 Ok, I played around a bit, rebooted, messed about - and suddenly this worked. Well, sort of. I now have an interface to read information, however, there's no way to set the CPU frequency; I can't find a write interface? # ls /sys/devices/system/cpu/cpu0/cpufreq/ cpuinfo_max_freq scaling_driver scaling_min_freq cpuinfo_min_freq scaling_governor scaling_available_governors scaling_max_freq No scaling_setspeed interface to be found ... This is with kernel 2.6.2 mm1. Anything else I can try. or anything I missed here? Thanks very much for the help so far, looks like this might end up working! Jesper