From: Jonathan Day Date: Sun, 21 Mar 2004 11:21:00 +0000 Subject: Re: [LARTC] How to route internal addresses? Message-Id: <20040321112100.26850.qmail@web12302.mail.yahoo.com> List-Id: References: <20040321084338.15201.qmail@web21005.mail.yahoo.com> In-Reply-To: <20040321084338.15201.qmail@web21005.mail.yahoo.com> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lartc@vger.kernel.org Although the original question was retracted, this does bring up an ionteresting point - how to make Linux treat certain IP ranges on certain devices as though it were a hub or switch, rather than a router, and/or route over the remainder. This is a much more specific and complex problem than merely copying traffic over via a bridge, as it means you can have the following scenario: Subnets A, B, C come in on card X Subnets D, E come in on card Y Subnet F comes in on card Z A goes to Y as per a hub, but routes to Z B goes to Y, Z as a switch The remainder are routed over all Arguably, hub/switch dynamics is beyond the scope of a routing list, but nobody can argue that this isn't an advanced problem in networking. --- Serban Murariu wrote: > Hey, > i have the following problem/question: > how can i route internal addresses? > my setup is sumthing like __________________________________ Do you Yahoo!? Yahoo! Finance Tax Center - File online. File on time. http://taxes.yahoo.com/filing.html _______________________________________________ LARTC mailing list / LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/