From: Edulix (by way of Edulix ) Date: Thu, 01 Jul 2004 13:41:05 +0000 Subject: [LARTC] filter ingress policy rates by packet marks Message-Id: <200407011541.06101.edulix@tumundoweb.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lartc@vger.kernel.org Hello everyone ! I'm new to the list :-). So I'll tell you: I'm Eduardo Robles Elvira aka Edulix, a young student from the south of Spain. I've developed a simple project for local pc bandwidth shaping called Edulix Shaper script [1]. It's based on the Wondershaper. I have it mostly finnished and debugged; I have only a final problem: Is it posible by any way using only QoS (no IMQ...) to filter incoming packets by its marks and at the same time rate them to spcified speed ? You can do: tc filter add dev $DEV parent ffff: protocol ip prio 10 u32 \ match ip src $Q_2_HOSTS \ police rate ${Q_2_DOWNLINK_MAX}mbit burst 10k drop flowid :2 and also: tc filter add dev $DEV protocol ip prio 5 parent 1: \ handle $Q_2_MARK fw classid 1:2 But can you have both commands mixed up so that we drop any incoming packet marked with $Q_2_MARK when they come at a higher speed than $Q_2_DOWNLINK_MAX? If that weren't possible I think I'd better remove outgoing marked packets rules for scripting coherence =). I'm still trying to upload the script to the webpage; If anyone is curious about it, I can send a 60 Kb tarball to you :-). Thanks for your time, Edulix. -- [1] http://eshaper.sf.net _______________________________________________ LARTC mailing list / LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/