From: Wolfgang Denk Date: Mon, 27 Sep 2004 22:34:24 +0200 Subject: [U-Boot-Users] the ppc405ep u-boot (with jffs2 configure) failed In-Reply-To: Your message of "Mon, 27 Sep 2004 11:22:44 PDT." <20040927182244.23840.qmail@web53408.mail.yahoo.com> Message-ID: <20040927203429.7CEB2C1430@atlas.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de In message <20040927182244.23840.qmail@web53408.mail.yahoo.com> you wrote: > > I am a new user, try to get the u-boot(with jffs2) > work on a ppc405ep board(32M Ram, 8M flash disk, one > serial port, one network port), it will has one > partition for u-boot(128k), the rest make one jffs2 > partition, the kernel and initrd will locate in this > JFFS2 partition. So you have at least these two partitions, right? > But after I configure u-boot JFFS2 support in > include/configs/PPC405EPVV.h, add 4 lines: > > #define CONFIG_COMMANDS ( CFG_CMD_JFFS2 ) > > #define CFG_JFFS2_FIRST_BANK 0 > #define CFG_JFFS2_FIRST_SECTOR 0 > #define CFG_JFFS2_NUM_BANKS 1 > > (the 8M flash memery havs one bank, 64 sector.) How many partitions did you configure here, and which sizes do they have? Best regards, Wolfgang Denk -- Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: wd at denx.de Prediction is very difficult, especially of the future. - Niels Bohr