From: Jhavk Date: Sun, 31 Oct 2004 21:17:52 -0800 (PST) Subject: [U-Boot-Users] Hello world application running problem In-Reply-To: <20041031211716.71155C146B@atlas.denx.de> Message-ID: <20041101051752.7411.qmail@web12010.mail.yahoo.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Thanks for all the valuable info. Actually i went thru the doc/README.standalone file and theres a table which tell abt load and entry point address of various architecture. For arm load = 0x0c100000 entry pt = 0x0c100000. I still have 2 doubts( hope it doesnt annoys u) 1.Cant i tftp my hello_world.bin to any valid address of RAM eg "tftp 0x30000000 hello_world.bin" 2.How do i find out the entry point of my binary image? Regards, Jhavk --- Wolfgang Denk wrote: > In message > <20041029154109.80624.qmail@web12009.mail.yahoo.com> > you wrote: > > > > > I have read README.standalone. My target board > is > > > smdk2440(Arm 9). > > > > > > So i transfer hello_world using tftp to address > > > 0x0c100000 and then call "go 0x0c100000 hello > world" > > What makes you think that 0x0c100000 is the > entry point of the > standalone application? > > > > But after that the application seems to get > stuck > > > and > > > nothing happens. Eventually i have to reset the > > > board. > > This is because you tried to run code where none is. > Pay attention to > the entry point address. > > > > I have some doubts: > > > 1. Which file should i send. I think it should > be > > This depends on which tool or protocol you use for > the download. > > > > hello_world and not the srec or bin format. I > ran > > This is wrong. hello_world is an ELF file, so it may > only be used by > tools / protocols that understand ELF files. The > SREC file has to be > used by tools / protocols that understand Motorola > S-Record files. > The BIN file has to be used by tools / protocols > that understand raw > binary images. > > > > command on all 3 and found that hello_world is > the > > > one meant for ARM. > > Wrong again. All images (hello_world, > hello_world.srec, > hello_world.bin etc) are all teh same images, > just in different > format, depnding on which protocols or tools you > want to use. > > > > 2.Is the load and start address correct? May be > its > > > different for ARM9? > > The load address ooks ok to me. The entry point is > probably somewhere > else. > > > Best regards, > > Wolfgang Denk > > -- > See us @ Embedded/Electronica Munich, Nov 09 - 12, > Hall A.6 Booth 513 > Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 > Email: wd at denx.de > Neckties strangle clear thinking. > -- Lin Yutang > __________________________________ Do you Yahoo!? Yahoo! Mail Address AutoComplete - You start. We finish. http://promotions.yahoo.com/new_mail