From: Wolfgang Denk Date: Sun, 05 Dec 2004 10:59:47 +0100 Subject: [U-Boot-Users] porting u-boot for new board In-Reply-To: Your message of "Sun, 05 Dec 2004 13:32:23 +0530." <41B2C08F.70308@GameBox.net> Message-ID: <20041205095952.4F26EC1430@atlas.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hello, in message <41B2C08F.70308@GameBox.net> you wrote: > > I want to port u-boot on our company new board. > I request you to find me a closer matching board, You should ne aware that all replies you may get can only be as good as the information you provide. > My board's specs are : These are not "specs". This is a useless summary. > CPU is MPC 8260 ==> So you can use any 8260 baed board. Just search the Makefile for "mpc8260". > 4MB Flash at cs0 > 128MB SDRAM at cs1 > 512K DPRAM at cs2 > 512 NVRAM at cs3 You don't bother to mention anything about chip types, bus width, or any other relevant parameters. All boards have flash and RAM, so you can use any one as model. > ARINC 429 at cs4 That's a databus protocol, not any type of chip. > DDC 1553 at cs5 As far as I know, DDC is a mnaufacturer and "1553" is probably MIL-STD-1553; there are several chips around to support this. > uart at smc1 Standard for 8260. > No PCI Bus. Of course not, as there is no PCI controller on the 8260. > I request your help in proving some pointers for porting u-boot for > this type of board. Such help is impossible, as your did not provide any useful information. Best regards, Wolfgang Denk -- Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de Little known fact about Middle Earth: The Hobbits had a very sophi- sticated computer network! It was a Tolkien Ring...