From: Wolfgang Denk Date: Sat, 12 Feb 2005 01:34:25 +0100 Subject: [U-Boot-Users] decrease boot time In-Reply-To: Your message of "Fri, 11 Feb 2005 23:30:35 +0100." <20050211223035.GA10412@ku-gbr.de> Message-ID: <20050212003430.658ADC1430@atlas.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de In message <20050211223035.GA10412@ku-gbr.de> you wrote: > > I am trying to improve boot time of my linux system on my motorola i.MX > system as much as possible. Therefore I tried to omit the copying and > decompressing the linux kernel image ba using XIP, but the code runs Are you sure that this is where you spend a significant part of your boot time? I guess you did run some analysis on which steps of the boot procedure take how long etc.??? > I wonder how to make use of sync burst mode with u-boot in conjunction What makes you think that this would solve a problem? > How do I disable serial support in u-boot? My u-boot is currently 60k > big, in my opinion a simple bootloader which does something like > memsetup and starting kernel afterwards should not be much bigger than > 10k. Or is that wrong? Your assumption may be of for "a simple bootloader", but then U-Boot is not such a beast. Also, which problem do you try to solve? Boot time? Image size? What makes you think that disabling the serial console would solve either of these problems? [If these actually are problems.] Best regards, Wolfgang Denk -- Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de There is a time in the tides of men, Which, taken at its flood, leads on to success. On the other hand, don't count on it. - T. K. Lawson