From: Wolfgang Denk Date: Mon, 20 Feb 2006 21:02:01 +0100 Subject: [U-Boot-Users] Fast flashing with MPCBDM In-Reply-To: Your message of "Mon, 20 Feb 2006 17:47:13 +0100." <43F9F291.9020807@informatik.stud.uni-erlangen.de> Message-ID: <20060220200201.2F1FE353C11@atlas.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de In message <43F9F291.9020807@informatik.stud.uni-erlangen.de> you wrote: > > when i write an uboot image to my flash with ppc-linux-gdb (with a > MPCBDM cable), i get from time to time the following message: > ---Type to continue, or q to quit--- ... > Can anybody please tell me how to get rid of this? I take it that it may be a two-pass sort of solution. In the first pass, RTFM. Then open your GDB manual, and try if you can find something that might be related to Controlling GDB, and if there is something written about the Screen size or so. Write down each step it took you to get the wanted information, so that you can repeat the procedure in case similar propblems come up later. Please also note that your posting is not related to U-Boot and thus off topic here. Hope this helps. Best regards, Wolfgang Denk -- Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de The ultimate barrier is one's viewpoint. - Terry Pratchett, _The Dark Side of the Sun_