From: Denis Vlasenko Subject: Re: How can I link the kernel with libgcc ? Date: Fri, 10 Mar 2006 12:37:35 +0200 Message-ID: <200603101237.35687.vda@ilport.com.ua> References: <4410D9F0.6010707@kenati.com> <1141961152.13319.118.camel@mindpipe> <4410F6CB.8070907@kenati.com> Mime-Version: 1.0 Content-Type: text/plain; charset="koi8-r" Content-Transfer-Encoding: 7bit Return-path: In-Reply-To: <4410F6CB.8070907@kenati.com> Content-Disposition: inline Sender: linux-kernel-owner@vger.kernel.org To: Carlos Munoz Cc: Lee Revell , Valdis.Kletnieks@vt.edu, linux-kernel@vger.kernel.org, alsa-devel List-Id: alsa-devel@alsa-project.org On Friday 10 March 2006 05:47, Carlos Munoz wrote: > Lee Revell wrote: > > >On Thu, 2006-03-09 at 19:25 -0800, Carlos Munoz wrote: > > > > > >>I figured out how to get the driver to use floating point operations. > >>I included source code (from an open source math library) for the > >>log10 function in the driver. Then I added the following lines to the > >>file arch/sh/kernel/sh_ksyms.c: > >> > >> > > > >Where is the source code to your driver? > > > >Lee > > > > > > > Hi Lee, > > Be warned. This driver is in the early stages of development. There is > still a lot of work that needs to be done (interrupt, dma, etc, etc). What? You are using log10 only twice! if (!(siu_obj_status & ST_OPEN)) { ... /* = log2(over) */ ydef[22] = (u_int32_t)(log10((double)(over & 0x0000003f)) / log10(2)); ... } else { ... if (coef) { ydef[16] = 0x03045000 | (over << 26) | (tap - 4); ydef[17] = (tap * 2 + 1); /* = log2(over) */ ydef[22] = (u_int32_t) (log10((double)(over & 0x0000003f)) / log10(2)); } Don't you think that log10((double)(over & 0x0000003f)) / log10(2) can have only 64 different values depending on the result of (over & 0x3f)? Obtain them from precomputed uint32_t log10table[64]. -- vda