From: antonio.dibacco Date: Wed, 10 May 2006 13:46:46 GMT Subject: [U-Boot-Users] Re: Usually dram test executed not on whole sdram In-Reply-To: <20060509220736.F3FF0353DB1@atlas.denx.de> References: <20060509220736.F3FF0353DB1@atlas.denx.de> Message-ID: <20060510134646.18278.qmail@mx1.aruba.it> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Thank you for your help Wolfgang, I disabled burst mode in ORx register of MPC880 and everything is fine. The UPM table has to be double checked. Now I want to look for a dram test that exercise the burst mode. It could be really useful in debugging these problems. Thank you very much, Bye. Wolfgang Denk Scrive: > In message <200605092241.38323.antonio.dibacco@aruba.it> you wrote: >> Anyone knows why in the u-boot normally the dram test is not executed on the >> whole DRAM? For example a lot boards that have 16MB specify start_address = >> 1MB and end_addr = 15MB. If the u-boot is executing in flash the DRAM can be >> written completely I think! > > The "mtest" can only be run after relocation to RAM, so you have to > leave out the memory needed ofr exception vectors, U-Boot code, > malloc arena, stack, etc. > > For the POST tests no such restriction exists. > > > But you are on the wrong track. A memory test will NOT detect your > problem, as it is exercising pleain read / write accesses only, while > your problem is most probably with burst mode accesses. Please read > the FAQ! > > Best regards, > > Wolfgang Denk > > -- > Software Engineering: Embedded and Realtime Systems, Embedded Linux > Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de > Success in marriage is not so much finding the right person as it is > being the right person.