From: khali@linux-fr.org (Jean Delvare) Date: Mon, 12 Jun 2006 19:48:08 +0000 Subject: [lm-sensors] [PATCH 05/14] scx200_acb: Documentation update Message-Id: <20060612214808.35510747.khali@linux-fr.org> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lm-sensors@vger.kernel.org Content-Disposition: inline; filename=i2c-scx200_acb-documentation-update.patch Documentation update for the scx200_acb driver. Hopefully this will help future users. References: [lm-sensors] Support of i2c-nscacb (April, May 2005) http://lists.lm-sensors.org/pipermail/lm-sensors/2005-April/011756.html http://lists.lm-sensors.org/pipermail/lm-sensors/2005-May/012043.html [lm-sensors] making a geode i2c slave driver (April 2006) http://lists.lm-sensors.org/pipermail/lm-sensors/2006-April/015998.html Kernel bug #6445 http://bugzilla.kernel.org/show_bug.cgi?idd45 Signed-off-by: Jean Delvare --- Documentation/i2c/busses/scx200_acb | 19 ++++++++++++++++++- 1 file changed, 18 insertions(+), 1 deletion(-) --- linux-2.6.17-rc3.orig/Documentation/i2c/busses/scx200_acb 2006-04-03 20:12:23.000000000 +0200 +++ linux-2.6.17-rc3/Documentation/i2c/busses/scx200_acb 2006-04-28 10:45:30.000000000 +0200 @@ -2,14 +2,31 @@ Author: Christer Weinigel +The driver supersedes the older, never merged driver named i2c-nscacb. + Module Parameters ----------------- -* base: int +* base: up to 4 ints Base addresses for the ACCESS.bus controllers on SCx200 and SC1100 devices + By default the driver uses two base addresses 0x820 and 0x840. + If you want only one base address, specify the second as 0 so as to + override this default. + Description ----------- Enable the use of the ACCESS.bus controller on the Geode SCx200 and SC1100 processors and the CS5535 and CS5536 Geode companion devices. + +Device-specific notes +--------------------- + +The SC1100 WRAP boards are known to use base addresses 0x810 and 0x820. +If the scx200_acb driver is built into the kernel, add the following +parameter to your boot command line: + scx200_acb.base=0x810,0x820 +If the scx200_acb driver is built as a module, add the following line to +the file /etc/modprobe.conf instead: + options scx200_acb base=0x810,0x820 -- Jean Delvare