From: Rodolfo Giometti Date: Tue, 4 Jul 2006 12:31:21 +0200 Subject: [U-Boot-Users] fb support for au1x000 Message-ID: <20060704103121.GC7631@gundam.enneenne.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hello, I'm trying to add support for frame buffer to my au1100 based board but I'm a bit confused where I can allocate the frame buffer memory. Looking at "lib_mips/board.c" I see: /* * Now that we have DRAM mapped and working, we can * relocate the code and continue running from DRAM. */ addr = CFG_SDRAM_BASE + gd->ram_size; /* We can reserve some RAM "on top" here. */ /* round down to next 4 kB limit. */ addr &= ~(4096 - 1); debug ("Top of RAM usable for U-Boot at: %08lx\n", addr); /* Reserve memory for U-Boot code, data & bss * round down to next 16 kB limit */ addr -= len; addr &= ~(16 * 1024 - 1); debug ("Reserving %ldk for U-Boot at: %08lx\n", len >> 10, addr); Where "len" is: len = (ulong)&uboot_end - CFG_MONITOR_BASE; So I think I can redefine "len" as follow: len = (ulong)&uboot_end - CFG_MONITOR_BASE + LCD_MEMORY_SIZE + PAGE_SIZE; and then adding the code: /* configure available FLASH banks */ size = flash_init(); display_flash_config (size); #ifdef CONFIG_LCD # ifndef PAGE_SIZE # define PAGE_SIZE 4096 # endif /* * reserve memory for LCD display (always full pages) */ /* bss_end is defined in the board-specific linker script */ addr = (uboot_end + (PAGE_SIZE - 1)) & ~(PAGE_SIZE - 1); size = lcd_setmem (addr); gd->fb_base = addr; #endif /* CONFIG_LCD */ bd = gd->bd; bd->bi_flashstart = CFG_FLASH_BASE; bd->bi_flashsize = size; to the function board_init_r(). Is that sane? Ciao, Rodolfo -- GNU/Linux Solutions e-mail: giometti at enneenne.com Linux Device Driver giometti at gnudd.com Embedded Systems giometti at linux.it UNIX programming phone: +39 349 2432127