From: David Brownell Subject: [patch 2.6.24-rc2 1/3] atmel_spi labels GPIOs better Date: Wed, 14 Nov 2007 21:21:35 -0800 Message-ID: <200711142121.36094.david-b@pacbell.net> Mime-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Cc: spi-devel-general-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org To: Andrew Morton Return-path: Content-Disposition: inline List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Sender: spi-devel-general-bounces-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org Errors-To: spi-devel-general-bounces-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org List-Id: linux-spi.vger.kernel.org Make the atmel_spi driver label GPIOs according to the device for which they're acting as a chipselect. This way the debugfs dump of gpio state is more informative. Signed-off-by: David Brownell --- a/drivers/spi/atmel_spi.c +++ b/drivers/spi/atmel_spi.c @@ -497,7 +497,7 @@ static int atmel_spi_setup(struct spi_device *spi) /* chipselect must have been muxed as GPIO (e.g. in board setup) */ npcs_pin = (unsigned int)spi->controller_data; if (!spi->controller_state) { - ret = gpio_request(npcs_pin, "spi_npcs"); + ret = gpio_request(npcs_pin, spi->dev.bus_id); if (ret) return ret; spi->controller_state = (void *)npcs_pin; ------------------------------------------------------------------------- This SF.net email is sponsored by: Splunk Inc. Still grepping through log files to find problems? Stop. Now Search log events and configuration files using AJAX and a browser. Download your FREE copy of Splunk now >> http://get.splunk.com/