From: Wolfgang Denk Date: Sun, 07 Sep 2008 01:10:15 +0200 Subject: [U-Boot] [PATCH] TQM5200 HIGHBOOT Makefile patch In-Reply-To: References: Message-ID: <20080906231015.DD52824815@gemini.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear "Pedro Luis D. L.", In message you wrote: > > I don't know the normal procedure, if I should send the patch to Wolfgang o= > r someone else, but I found a problem with Makefile and TQM5200 HIGHBOOT co= > nfig in Makefile. I think this problem is also in previous versions since t= > qm boards where moved under tqc folder. Please use a line length not longer than some 70+ characters. > The patch is: > > --- a/Makefile 2008-09-04 14:55:05.000000000 +0200 > +++ b/Makefile 2008-09-04 14:56:14.000000000 +0200 > @@ -755,7 +755,7 @@ > echo "#define CONFIG_TQM5200_B" >>$(obj)include/config.h ; \ > } > @[ -z "$(findstring HIGHBOOT,$@)" ] || \ > - { echo "TEXT_BASE =3D 0xFFF00000">$(obj)board/tqm5200/config.tmp ; \ > + { echo "TEXT_BASE =3D 0xFFF00000">$(obj)board/tqc/tqm5200/config.tmp ; \ > } > @$(MKCONFIG) -n $@ -a TQM5200 ppc mpc5xxx tqm5200 tqc Please re-submit after adding your Signed-off-by: line (and please follow the other instructions Detlev sent you). Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de Were there fewer fools, knaves would starve. - Anonymous