From: Wolfgang Denk Date: Fri, 31 Oct 2008 12:26:32 +0100 Subject: [U-Boot] U-boot support for Non Console board In-Reply-To: <843260.87725.qm@web50008.mail.re2.yahoo.com> References: <843260.87725.qm@web50008.mail.re2.yahoo.com> Message-ID: <20081031112632.64E13874F93F@gemini.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear rajeev s, In message <843260.87725.qm@web50008.mail.re2.yahoo.com> you wrote: > > We have a custom board based on coldfire (MCF5484) Similar to MCF5484 Kitlite > The board runs Coldfire as PCI agent , 64MB of SDRAM, 4 MB of Bootflash and the PCI bus as a slave (no serial > port->no console) > I can flash U-boot using the JTAG . Can you let know how can i pass the Commands over PCI . > I do not have a Console to do that ? Well, somebody who designed this system must also have had some plan how to operate the board? Not having a console port sounds like a really stupid thing to me. If you have ethenret on your board, you can try netconsole. But it will be no fun to port U-Boot to such hardware. I suggest you bring the board back to the hardware guys and ask for a serial console port, at least for bring-up and debugging. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de "In matrimony, to hesitate is sometimes to be saved." - Butler