From: Jean-Christophe PLAGNIOL-VILLARD Date: Sat, 8 Nov 2008 20:09:08 +0100 Subject: [U-Boot] [PATCH-OMAP3] OMAP3: Use I2C file coding style In-Reply-To: <49107931.25e2660a.2bad.3cc1@mx.google.com> References: <49107931.25e2660a.2bad.3cc1@mx.google.com> Message-ID: <20081108190908.GC19090@game.jcrosoft.org> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 17:32 Tue 04 Nov , dirk.behme at googlemail.com wrote: > Subject: [PATCH-OMAP3] OMAP3: Use I2C file coding style > > From: Dirk Behme > > Use file coding style for inx/outx instead of global coding style. > > Signed-off-by: Dirk Behme > > --- > > Note: There was an additional review comment about this file: > > -- cut -- > > +#define inb(a) __raw_readb(a) > > +#define outb(a, v) __raw_writeb(a, v) > > #define inw(a) __raw_readw(a) > > #define outw(a,v) __raw_writew(a,v) > > This 4 macro is supposed to be defined in io.h > -- cut -- > > In ARM's io.h there are already inx/outx macros, but with different syntax. The correct fix for omap24xx_i2c.c will be to replace all inx/outx by readx/writex macros and remove above defines. But this can't be done on OMAP3 branch, as it would conflict with "no general coding style clean up in OMAP3 patches, only OMAP3 related changes, please". Thus, we have to do code style changes for this file at mainline once OMAP3 is merged. Until then we have to stay with consistent local style. I desagree, This fix is supposed to be done before appling of the OMAP3 patch set not after. please do not add code which need to fix just after. NB : applied to the omap3 branch Best Regards, J.