From: Wolfgang Denk Date: Fri, 23 Jan 2009 16:22:47 +0100 Subject: [U-Boot] Common u-boot image for e300 and e500v2 In-Reply-To: References: Message-ID: <20090123152247.68551832E425@gemini.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear Johns Daniel, In message you wrote: > Is it possible -- and prudent -- to use a single u-boot binary image > for two similar boards, one based on an e300 core and the other on an > e500v2 core? No, this is not possible (at least not with reasonable efofort and resonable code). > My guess is that it is not possible, but I was surprised to see that > the e500v2-targeted toolchain did build the kernel for the e300 board > just fine. That's not surprise. When testing, I build U-Boot for *all* PowerPC systems with the same toolchain, usually using a ppc_8xx- or ppc_4xx- configuration. All these images buil without problems, and more, they even run fine on the target systems. U-Boot usually does not include any code which depends on such specific CPU features. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de "One thing they don't tell you about doing experimental physics is that sometimes you must work under adverse conditions... like a state of sheer terror." - W. K. Hartmann