From: Jean-Christophe PLAGNIOL-VILLARD Date: Fri, 6 Feb 2009 18:47:38 +0100 Subject: [U-Boot] [PATCH] at91: Factored out common serial hardware initialization In-Reply-To: <1233929554-11483-2-git-send-email-mroth@nessie.de> References: <1233929554-11483-1-git-send-email-mroth@nessie.de> <1233929554-11483-2-git-send-email-mroth@nessie.de> Message-ID: <20090206174738.GJ4580@game.jcrosoft.org> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 15:12 Fri 06 Feb , Michael Roth wrote: > Created a new function at91_serial_hw_init() which sets up the > dedicated PIO pins of several at91 SoC according to CONFIG_USARTx. > > Please note that the used pins for serial communication varies on > different at91 SoC independently of the logic functionality equality > of the serial hardware. But for each serial channel there is only > one possibility for IO pin multiplexing so there is no need for board > specific PIO setup. So the usage of SoC specific PIO setup is advisable. > > Signed-off-by: Michael Roth please do remove my Copyright and orignial sob I've done this for the serial to add multiple serial support please do not remvoe Best Regards, J.