From: Wolfgang Denk Date: Tue, 10 Feb 2009 00:54:56 +0100 Subject: [U-Boot] 82xx serial, smc: add configurable SMC Rx buffer len In-Reply-To: <4982EABA.7090901@denx.de> References: <4982EABA.7090901@denx.de> Message-ID: <20090209235456.5536C832E893@gemini.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear Heiko Schocher, In message <4982EABA.7090901@denx.de> you wrote: > This patch adds the configuration option CONFIG_SYS_SMC_RXBUFLEN. > With this option it is possible to allow the receive > buffer for the SMC on 82xx to be greater then 1. In case > CONFIG_SYS_SMC_RXBUFLEN == 1 this driver works as the > old version. > > When defining CONFIG_SYS_SMC_RXBUFLEN also > CONFIG_SYS_MAXIDLE must be defined to setup the maximum > idle timeout for the SMC. > > Signed-off-by: Heiko Schocher > --- > README | 8 ++++ > cpu/mpc8260/serial_smc.c | 97 ++++++++++++++++++++++++++++----------------- > 2 files changed, 68 insertions(+), 37 deletions(-) Applied, thanks. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de If a packet hits a pocket on a socket on a port, And the bus is interrupted as a very last resort, And the address of the memory makes your floppy disk abort, Then the socket packet pocket has an error to report! - Ken Burchill?