From: Wolfgang Denk Date: Wed, 18 Feb 2009 09:06:53 +0100 Subject: [U-Boot] [PATCH] 7/12 Multiadapter/multibus I2C, drivers part 4 In-Reply-To: <499BB9C6.6010602@denx.de> References: <499548C2.7060305@denx.de> <49967FAC.6090905@denx.de> <20090216221151.08966832E893@gemini.denx.de> <20090217224940.02BC6832E893@gemini.denx.de> <499BB9C6.6010602@denx.de> Message-ID: <20090218080653.CC4D8832E43F@gemini.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear Heiko Schocher, In message <499BB9C6.6010602@denx.de> you wrote: > > > You convinced me. This code must not be used before relocation to RAM, > > then. > > But is is possible to use that code when running from flash, if > this current pointer is writeable ... Yes, it is possible, but then - ther eis no need for it. > > Yes, it is, because none of them needs any such switching before > > relocation. And switching is really simple so far. > > They use it before relocation, because the DTTs are read before relocation. I am not aware that any piece of code in the init sequence makes use of the information read from the DTT's, so why is this performaned before relocation? More - why is this performed at all for each reset cycle? Normally we should not even initialize interfaces that are nt used for U-Boot's own operation. I think the automatic DTT checking should be dropped. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de How can you tell when sour cream goes bad?