From: Frans Pop Subject: Re: [RFC][PATCH] sata_mv: harddisk activity led no longer responsive on QNAP TS-109 Date: Sun, 1 Mar 2009 13:44:17 +0100 Message-ID: <200903011344.18888.elendil@planet.nl> References: <200808261124.39282.elendil@planet.nl> <20090301075956.GA28039@deprecation.cyrius.com> Mime-Version: 1.0 Content-Type: text/plain; charset="iso-8859-1" Content-Transfer-Encoding: 7bit Return-path: Received: from hpsmtp-eml17.KPNXCHANGE.COM ([213.75.38.117]:13473 "EHLO hpsmtp-eml17.kpnxchange.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1752693AbZCAM7e (ORCPT ); Sun, 1 Mar 2009 07:59:34 -0500 In-Reply-To: <20090301075956.GA28039@deprecation.cyrius.com> Content-Disposition: inline Sender: linux-ide-owner@vger.kernel.org List-Id: linux-ide@vger.kernel.org To: Martin Michlmayr Cc: saeed bishara , Mark Lord , linux-arm@vger.kernel.org, linux-ide@vger.kernel.org, Saeed Bishara , Nicolas Pitre , Lennert Buytenhek On Sunday 01 March 2009, Martin Michlmayr wrote: > * saeed bishara [2009-02-24 11:33]: > > What I think is that this issue is seen with the specific disk that > > you have, the chip blinks the LED depending on the BUSY bit status, > > and I suspect that with the disk you have does clear that bit > > immediately after receiving the command FIS, so the LED will be off, > > though the command is not completed yet, and this makes the led > > responsiveness differ that in NCQ-disabled mode. > > The LED issue was reported by two people on the QNAP forum the other > day. I asked what disks they had and one has a WDC WD7500AACS-00D6B0 > whereas the other one has a WDC WD10EADS-00L5B1. Do you also use a > WDC disk, Frans? I always was rather doubtful of Saeed's analysis (with all due respect), but it's good to see confirmed that the same problem manifests with other disks too. I have a completely different HD: Model Family: Hitachi Deskstar T7K250 series Device Model: HDT722516DLA380 Firmware Version: V43OA91A User Capacity: 164,696,555,520 bytes Cheers, FJP